Emergency Disinfection of Drinking Water

This information is provided for the use of the individual householder when the treatment and distribution facilities of a public or private water system cannot be operated on a normal basis, when a water supply has become flooded, when an extended power failure renders a water system inoperable, or when the bacterial quality of available water is suspect. The methods described in this leaflet will not remove or reduce toxic, chemical or radiological contaminants and water exposed to such contamination should not be used.

Sources of Safe Water During an Emergency

1. Contact your local health department and ask where emergency drinking water distribution points are located. Take along clean covered containers which have not previously contained harmful substances (read the label).

2. If you know in advance that water will not be available for a long period of time, store some in clean covered containers. The bathtub may even be used. A supply of water is also available in the water heater and holding tank (not the bowl) of toilets. However, such water should be purified according to one of the methods below. (If water is drained from a hot water heater, the heater must be turned off).

3. Safe water is available from many other sources in the home such as ice cubes, juices, soft drinks, milk, or other food item liquids, provided the items have not been submerged in flood waters.

Methods to Purify Water For Drinking

Boiling

If the available water contains any suspended material or is cloudy, the water is to be strained through several layers of clean cloth or the water allowed to settle and the clearer water drawn off into a clean covered container.

Boil the water vigorously at or near 212 F (100 C) for one full minute to kill any disease causing bacteria that may be present in the water. (A microwave oven may be used to boil the water.)

The flat taste of boiled water may be improved by pouring it back and forth between two clean containers before use.

Chlorination

When boiling is not practical, common household laundry bleach usually contains a chlorine compound that can disinfect water. (Check the label on the bottle to make sure it indicates the solution is 5.25% sodium hypochlorite with no additional active ingredients.)

If the water contains any suspended material or is cloudy, strain the water through several layers of clean cloth or allow material to settle and draw off the clearer water.

If an unopened bottle of bleach is available, use the new bottle to add the appropriate following number of drops to disinfect the water. If you do not have a dropper, use a clean utensil such as a knife to dip into the bleach and let the drops fall into the water as you count them (16 drops are approximately equal to 1/8 of a teaspoon

Liquid Chlorine Bleach To Be Added
(Label should read 5.25% Sodium Hypochlorite)

Mix thoroughly by stirring or shaking and let stand for at least 30 minutes. A slight chlorine odor should be detectable in the treated water. If it is not, repeat the chlorine dose and let stand for an additional 20 minutes before use.

The taste of the treated water may be improved by pouring it back and forth between two clean containers or by allowing it to stand for a few hours before use.

Iodine

A tincture of iodine from a home medicine chest, a first aid kit, or the local pharmacy may be used to disinfect water.

If the water contains any suspended material or is cloudy, strain the water through several layers of clean cloth or allow to settle and draw off the clearer water into a clean container.

Add the appropriate following number of drops of iodine to disinfect the water.

Tincture of Iodine To Be Added

Mix water and iodine thoroughly by stirring or shaking water in the container. Allow to stand for at least 30 minutes after which time the water is safe to use.

Water Purification Tablets

Many commercial tablets which release chlorine or iodine are available for disinfection of water. They are usually available at drug stores or sporting goods stores. Follow the manufacturers directions on the label for proper use.

How to Disinfect Water Wells ( A CDC link)

General Comments

Keep the disinfected water in clean and covered containers until use. All water used for drinking, cooking, making prepared drinks, brushing teeth or bathing should be properly disinfected before use.